Crankshaft Position Sensor: Service and Repair

Crankshaft Position (CKP) Sensor:

REMOVE OR DISCONNECT
1. Sensor harness connector at sensor.
2. Sensor to block bolt (1).
3. Sensor from engine.

INSPECT
^ Sensor O-ring for wear, cracks or leakage. Replace if necessary. Lube new O-ring with engine oil before installing.

INSTALL OR CONNECT
1. Sensor to hole in block.
2. Sensor to block bolt (1).

^ Tighten bolt to 10 Nm (89 lb in)

3. Sensor harness connector.