Ignition Switch

Fig. 2 Ignition & Dimmer Switch Replacement. Fixed Column:

WARNING:
On models equipped with Airbags, Refer to Air Bags (Supplemental Restraint Systems) Service and Repair Disarming procedures before performing any repair. Service and Repair

1. Remove ignition lock. Refer to Ignition Lock / Service and Repair.
2. Refer to Fig. 2 for ignition and dimmer switch replacement procedures.
3. Remove washer and hex nut.
4. Disconnect dimmer switch assembly from rod.
5. Remove dimmer switch and ignition switch mounting stud.
6. Remove ignition switch from ignition switch actuator assembly.
7. Disconnect turn signal switch assembly electrical connector from bulkhead connector.
8. Remove pivot and switch assembly connector from bulkhead connector.
9. Reverse procedure to install.