Ignition Lock Cylinder

WARNING:
On models equipped with Airbags, Refer to Air Bags (Supplemental Restraint Systems) Service and Repair Disarming procedures before performing any repair. Service and Repair

1. Remove turn signal switch. Refer to Lighting and Horns / Turn Signals / Turn Signal Switch. Service and Repair
2. Remove buzzer switch and spring clip. Ignition key must be removed from lock to remove buzzer switch. Switch and spring clip are one assembly.
3. Turn lock cylinder to Run position, then remove lock cylinder retaining screw and the lock cylinder.
4. To install, rotate lock cylinder to the stop while holding housing. Align cylinder key with keyway in housing, then push lock cylinder into housing until fully seated. Lock cylinder must be in Run position to install buzzer switch.
5. Install lock cylinder retaining screw, then the buzzer switch, turn signal switch and steering wheel.