Servicing Quick-Connect Fittings

REMOVE OR DISCONNECT
1. Grasp both sides of the quick-connect fitting. Twist the female connector 1/4 turn in each direction in order to loosen any dirt within the quick-connect fitting.






WARNING: Wear safety glasses when using compressed air because flying dirt particles may cause eye injury.

2. Blow any dirt out of the quick-connect fitting using compressed air.
3. Squeeze the plastic retainer release tabs.
4. Pull the connection apart.

NOTE: If it is necessary to remove rust or burrs from a fuel pipe, use emery cloth in a radial motion with the fuel pipe end in order to prevent damage to the O-Ring sealing surface.

5. Using a clean shop towel, wipe off the male fuel pipe end.
6. Inspect both ends of the quick-connect fitting for dirt and burrs.
7. Clean or replace components/assemblies as required.










INSTALLATION PROCEDURE

WARNING: In order to Reduce the Risk of Fire and Personal Injury: Before connecting the fuel pipe quick-connect fitting, always apply a few drops of clean engine oil to the male fuel pipe end. This will ensure proper reconnection and prevent a possible fuel leak. (During normal operation, the O-Rings located in the female connector wall swell and may prevent proper reconnection if not lubricated.)

1. Apply a few drops of clean engine oil to the male fuel pipe end.
2. Push both sides of the quick-connect fitting together in order to cause the retaining tabs/fingers to snap into place.
3. Once installed, pull on both sides of the quick-connect fitting in order to make sure the connection is secure.