Keyless Entry: Service and Repair

Transmitter Programming

Remote Control Door Lock Receiver Programming Connector (Sedan):

Remote Control Door Lock Receiver Programming Connector (Wagon):

1. Reposition rear compartment trim to access the programming connector located at the left of the rear compartment, for sedan.
2. Remove left back body pillar finish panel to access programming connector, for wagon.
3. Ground the programming connector by connecting the terminals together.
^ The system will verify this has occurred by performing a lock all, unlock drivers door/unlock all, and trunk/endgate cycle.
4. Press any key on either transmitter.
^ This step programs that particular transmitter to the receiver.
^ The system will verify by performing the same lock/unlock. lock/unlock cycle.
5. The Automatic Door Locking/Unlocking function is automatically enabled for this transmitter. To leave it enabled, skip to step 6. To disable the Automatic Door Locking/Unlocking function for this transmitter, perform the following sequence 3 times.
A. Press door lock button within 1 second of step C the 2nd and 3rd time through this sequence.
B. Press door unlock button within 1 second of step A.
C. Press trunk button within 1 second of step B.
^ The receiver will cycle through the lock, unlock, trunk sequence 3 times as verification.
6. To program a second transmitter to the receiver, repeat step 4 with the second transmitter. Otherwise, go to 7.
7. Disconnect the programming connector.
^ System will not operate if ground connection is not removed.
8. Verify operation of each transmitter.
9. Reposition rear compartment trim, for sedan.
10. Install left back body pillar finish panel, for wagon.