Turn Lamps

With the Ignition Switch in "RUN," "BULB TEST" or "START," voltage is applied from I/P Fuse #12 and the Turn Flasher to the normally closed pole of the Hazard Switch in the Turn/Hazard Switch Assembly. With the Turn Switch in the "TURN LEFT" position, voltage is applied from the Turn Switch to CKT 14 at terminal "H" of the Turn Signal Switch connector C210 and to CKT 18 at terminal "M" of C210. LH Front Turn, Rear Turn and Indicator Lamps flash "ON" and "OFF" as current flow heats up the timing element in the Turn Flasher, and it continuously opens and closes the circuit (for RH Turn Lamps CKT 15 terminal "J" of C210 and CKT 19 terminal "N" of C210). With Park Lamps "ON" and Turn Lamps "ON." voltage is applied to both terminals of the Front Marker Lamp causing it to be "OFF." When the Front Turn Lamp is "OFF," voltage is applied to only one terminal of the Marker Lamp causing it to flash "ON." They continue to flash "ON" and "OFF" out of sequence until Turn Switch is turned "OFF."