Troubleshooting Hints - Exterior Lights

PERFORM BEFORE BEGINNING SYSTEM DIAGNOSIS
1. Check the TAIL LPS, TURN, HTR-A/C, and STOP-HAZ Fuses.
2. If the Turn/Hazard Flasher cycles continuously on and off, check CKT 16 and CKT 27 for short to ground.
^ Check for a broken (or partially broken) wire inside of the insulation which could cause system malfunction but prove "GOOD" in a continuity/voltage check with a system disconnected. These circuits may be intermittent or resistive when loaded, and if possible, should be checked by monitoring for a voltage drop with the system operational (under load).
^ Check for proper installation of aftermarket electronic equipment which may affect the integrity of other systems (See Diagnostic Aids for General Troubleshooting Procedures). Diagnostic Aids
^ Refer to Turn/Hazard-Headlamp Switch Assembly Access.
^ Refer to Lamp Bulb access.