Rehome Procedure

With Tech 1 (Preferred Method)

1. Using Tech or T-100 (CAMS), select "F5: Motor Rehome." The motor rehome function cannot be performed if current DTCs are present. If DTCs are present, the vehicle must be repaired and DTCs cleared before performing the motor rehome function.
2. The entire brake system should now be bled following either "Pressure Bleeding" or "Manual Bleeding" outlined below.

Without Tech 1

Note: This method can only be used if the ABS warning lamp is not illuminated and no DTCs are present.

Important: Do not place your foot on the brake pedal through this entire procedure unless specifically directed to do so.

1. Remove foot from brake pedal.
2. Start engine and allow it to run for at least 10 seconds while observing the ABS warning lamp.
3. If the ABS warning lamp turned "ON" and stayed "ON" after about 10 seconds, the bleeding procedure must be stopped and a Tech 1 must be used to diagnose the ABS malfunction.
4. If the ABS warning lamp turned "ON" for approximately 3 seconds, then turned "OFF" and stayed "OFF," turn the ignition "OFF."
5. Repeat Steps 1 though 4 one more time.
6. The entire brake system should now be bled following either "Pressure Bleeding" or "Manual Bleeding" procedures.