Engine Installation
1. Install the engine to the vehicle.2. Remove the engine lifting device.
3. Remove the floor stands from the transaxle.
4. Remove the safety bolt from the generator bracket and the front engine lift bracket.
5. Install the upper engine to transaxle bolts. See Transmission and Drivetrain.
6. Raise and suitably support the vehicle.
7. Install the lower engine to transaxle bolts. See Transmission and Drivetrain.
8. Install the torque converter bolts. See Transmission and Drivetrain.
9. Install the starter motor. See Starting and Charging.
10. Install the engine mount lower nuts.
11. Install the transaxle brace. See Transmission and Drivetrain.
12. Install the transaxle fluid filler tube. See Transmission and Drivetrain.
13. Connect the three-way catalytic converter pipe to the right (rear) exhaust manifold. See Exhaust System.
14. Lower the vehicle.
15. Install the automatic transaxle vacuum modulator pipe. See Transmission and Drivetrain.
16. Install the fuel lines. See Powertrain Management.
17. Connect the vacuum hoses from the engine to the body. See Powertrain Management.
18. Connect the vacuum booster hose to the upper intake manifold. See Powertrain Management.
19. Connect the lower radiator hose to the water pump. See Cooling System.
20. Connect the upper radiator hose to the engine. See Cooling System.
21. Connect the heater inlet hose hose from the inlet pipe. See Heating and Air Conditioning.
22. Connect the heater outlet hose hose from the thermostat bypass pipe. See Heating and Air Conditioning.
23. Install the power steering pump with lines. See Steering and Suspension.
24. Install the accelerator control cable bracket with accelerator control and cruise control servo cables.
25. Install the accelerator control and cruise control servo cables to the throttle body. See Powertrain Management.
26. Connect engine wiring harness connectors to the engine components, the engine sensors and the engine grounds. See Powertrain Management.
27. Install the right engine mount strut bracket.
28. Install the engine mount struts.
29. Install the air cleaner duct. See Powertrain Management.
30. Install the hood panel. See Body and Frame.
31. Fill the cooling system with coolant. See Cooling System.
32. Fill the engine with oil.
33. Connect battery ground (negative) cable.