Operation CHARM: Car repair manuals for everyone.

A/C Cpmpressor Clutch Control



Circuit Description
When A/C is selected through the A/C control head a 12 volt signal is supplied to the A/C request input of the PCM. The A/C compressor clutch relay is controlled through the PCM. The PCM monitors the A/C refrigerant pressure. If the A/C refrigerant pressure, and engine operating conditions are within a specific calibrated acceptable ranges the PCM will enable the A/C compressor relay. This is accomplished by providing a ground path for the A/C relay coil within the PCM. When the A/C compressor relay is enabled battery voltage is supplied to the compressor clutch coil.

The PCM will enable the A/C compressor clutch whenever the engine is running and the A/C has been requested, unless any of the following conditions are met:
- Throttle greater than 90%.
- A/C head pressure greater than 414 psi (4.27 volts) or less than 34 psi (0.35 volt) (as determined by the A/C refrigerant pressure sensor).
- Ignition voltage below 10.5 volts.
- Engine speed greater than 4500 RPM for 5 seconds or 5400 RPM.
- ECT greater than 125°C (257°F). IAT less than 5°C (41 °F).