Antenna Assembly

CELLULAR ANTENNA INSTALLATION
External Foot with Mast
Remove Or Disconnect
^ To remove, use razor blade or putty knife, cut double back tape material while lifting up on External Foot.

Install Or Connect
1. Clean exterior glass mounting area and External Foot with alcohol and dry thoroughly with lint free cloth.
2. Apply new double back tape. (Obtain kit from SPO.)
3. Peel backing paper from exterior mounting.
4. Mount foot in center of glass approximately one inch below dark edge shading on glass.
5. Press firmly on all four corners to ensure proper bonding between adhesive and glass.

Interior Coupling Box
Remove Or Disconnect
^ To remove, use razor blade or pully knife, cut double back tape material while lifting up on Internal Coupling Box.

Install Or Connect
1. Thoroughly clean Interior Coupling Box and interior glass at opposite mounting area of external antenna position using alcohol and dying with a lint free cloth.
2. Apply new double back tape. (Obtain repair kit from SPO.)
3. Peel back paper from interior coupling box.
4. Align Interior Coupling Box with exterior mount.
NOTE: Interior Coupling Box has RF connections, these connections point upward towards headliner.

5. Press Interior Coupling Box onto back glass using even firm pressure at all four comers.

Coax Cable
Remove Or Disconnect
1. Remove right rear sail panel trim.
2. Pull cable from behind headliner.
3. Cable from transceiver.
4. Pull cable through hole in package shelf.

Install Or Connect
1. Route coax cable from rear compartment through hole in passenger side of package shelf.
2. Pull cable into interior of vehicle, screw onto RF connection on interior coupling box.
3. Slide coax cable under headliner to conceal.
4. Reinstall right sail panel trim.
5. Plug cable into transceiver.