System Diagnosis - Fuel Metering System

Some failures of this system will result in an Engine Cranks But Will Not Run symptom. If this condition exists, refer to Engine Cranks but Does Not Run. This will determine if the problem is caused by the ignition system, the PCM, or the fuel pump electrical circuit. Engine Cranks, But Will Not Run

Refer to Fuel Pump Relay Circuit Diagnosis for the fuel system wiring schematic. Circuit Diagnosis - Fuel Pump Relay

If there is a fuel delivery problem, refer to Fuel System Pressure Test, diagnoses the fuel injectors, the fuel pressure regulator, and the fuel pump. System Diagnosis - Fuel System Pressure Test

If a malfunction occurs in the fuel metering system, it usually results in either a rich HO2S signal or lean HO2S signal. This condition is indicated by the HO2S voltage, causing the PCM to change the fuel calculation (fuel injector pulse width) based on the HO2S reading.

System Diagnosis - Fuel System Pressure TestChanges made to the fuel calculation will be indicated by a change in the long term fuel trim values which can be monitored with a scan tool. Ideal long term fuel trim values are around 0%; for a lean HO2S signal, the PCM will add fuel, resulting in a fuel trim value above 0% and for a rich HO2S signal the PCM will take away fuel, resulting in a fuel trim value below 0%. Some variations in fuel trim values are normal due to power train design. If the fuel trim values are excessively greater or lower then 0% Refer to DTC P0171 Fuel Trim System Lean or DTC P0172 Fuel Trim System Rich. Testing and Inspection

The scan tool displays IAC pintle position in counts. 0 counts indicates the PCM is commanding the IAC pintle to be driven all the way into a fully seated position. This is usually caused by a vacuum leak. The higher the number of counts, the more air is being commanded to bypass the IAC pintle. Refer to Idle Air Control System Check in order to diagnose the IAC system. System Check - Idle Air Control (IAC )

Refer to Rough, Unstable, or Incorrect Idle, Stalling, for other possible causes of idle problems. Rough, Unstable, or Incorrect Idle, Stalling