Tilt Head Assembly

^ Tools Required:
- J 23653-SIR Lock Plate Compressor
- J 21854-01 Pivot Pin Remover
- J 242137 Lock Plate Compressor Adapter
- Or Equivalents

REMOVAL PROCEDURE
1. Do all steps, under "REMOVAL PROCEDURE," refer to SIR COIL ASSEMBLY.
2. Do steps 3 and 4, under "REMOVAL PROCEDURE," refer to T/S & MULTIFUNCTION SWITCH ASM.
3. Do steps 2 through 8, under "REMOVAL PROCEDURE," refer to LINEAR SHIFT ASM (REMOVAL).
4. Do steps 2 through 7, under "REMOVAL PROCEDURE," refer to UPPER TILT HEAD COMPONENTS.
5. Do steps 5 through 10, under "REMOVAL PROCEDURE," refer to LOCK MODULE ASM.
6. Do steps 3 through 5, under "REMOVAL PROCEDURE," refer to TILT SPRING.





7. Remove two pivot pins using J21854-01.

Important: Mark race & upper shaft assembly (34) and lower steering shaft assembly (37) to ensure proper assembly. Failure to assemble properly will cause steering wheel to be turned 180°.





8. Remove steering column tilt head assembly.
^ Pull tilt arm to disengage steering wheel lock shoes from dowel pins in steering column support assembly.

INSTALLATION PROCEDURE

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems. Failure to do so may result in component damage or malfunction of steering column.





1. Install steering column tilt head assembly.
^ Using tilt lever position lock shoes to dowel pins.
^ Rotate head assembly until holes for pivot pins line up.





2. Install two pivot pins.
A. Lubricate with lithium grease.
B. Press pins until firmly seated two places.
C. Stake pins three locations two places.
3. Do step 2, under "INSTALLATION PROCEDURE," refer to TILT SPRING.
4. Do steps 2 through 6, under "INSTALLATION PROCEDURE," refer to LOCK MODULE ASM.
5. Do steps 1 through 6, under "INSTALLATION PROCEDURE," refer to UPPER TILT HEAD COMPONENTS.
6. Do steps 1 through 5, under "INSTALLATION PROCEDURE," refer to LINEAR SHIFT ASM (REMOVAL).
7. Do all steps, under "INSTALLATION PROCEDURE," refer to SIR COIL ASSEMBLY.