Rear Suspension
REMOVE OR DISCONNECT1. Rear suspension support assembly.
2. On left control arm remove Electronic Level Control (ELC) height sensor 1ink.
3. Stabilizer link bolt and nut.
4. ABS electrical connector.
5. Hub and bearing, if necessary.
6. Bolt and nut securing control arm to rear suspension support assembly.
7. Control arm.
INSTALL OR CONNECT
1. Control arm to rear suspension support assembly.
^ Control arm nuts should be tightened with the vehicle unsupported and resting on its wheels at normal trim height.
2. Bolts and nuts.
3. Hub and bearing, if necessary.
4. ABS electrical connector.
5. Stabilizer link bolt and nut.
^ Tighten nut to 17 Nm (13 ft. lbs.).
6. On left control arm install ELC height sensor link.
7. Rear suspension support assembly.
8. Lower vehicle.
9. Tighten control arm nuts to 106 Nm (78 ft. lbs.).