Input Clutch Housing Oil Seal Rings Assemble

^ Tools Required:
- Input Seal Installer
- J 34741-1A Adjustable Seal Protector
- J 34741-2 Seal Pusher
- J 34741-3 Seal Sizer





1. Install J 34741-1A into the input clutch housing (632). Adjust J34741-1A so that the bottom of the seal installer aligns with the lowest seal ring groove.
- Use transmission fluid in order to lubricate the oil seal ring for the input clutch housing.
2. Position the ring on the J34741-1A.





3. Position J 34741-2 onto the J 34741-1A. Push the seal (628) into the seal ring groove.





4. Repeat this procedure for the second and the third seal rings (628).





5. Remove the input seal installer.
6. Use a twisting motion in order to assemble J 34741 -3 over the seals.
7. Leave J 34741-3 in place until the input clutch housing assembly (632) is assembled into the transmission.