P1630

Diagnostic Chart:

Circuit Description

The PASS-Key(R) III system is incorporated within the Body Control Module. If the Body Control Module has been replaced, the password must be relearned using approved Techline diagnostic equipment. If the PCM is replaced, the replacement PCM should learn the password within a few seconds after the ignition is turned ON. DTC P1630 is an information code indicating that the PCM is ready to learn the vehicle theft deterrent password. The engine will start and continue to run with DTC P1630 set.

Conditions for Setting the DTC

^ The PASS-Key(R) III system has allowed fuel delivery.

^ The PCM is in the theft deterrent password learn mode.

Action Taken When the DTC Sets

^ The PCM will not illuminate the Malfunction Indicator Lamp (MIL).

^ The PCM will store conditions which were present when the DTC set as Fail Records data only. This information will not be stored as Freeze Frame data.

Conditions for Clearing the MIL/DTC

^ A history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.

^ DTC can be cleared by using the scan tool Clear Info function or by disconnecting the PCM battery feed.


Diagnostic Aids

A new replacement PCM will be in a functional state to learn the password from the PASS-Key(R) III module. If the PASS-Key(R) III module is replaced, the PCM must be placed in password learning mode to relearn a new password. Once learned, the password becomes permanent information that remains with the vehicle. The loss of PCM battery or ignition voltage will not affect the programmed password information.