Brake Pedal

REMOVE OR DISCONNECT
1. Driver's side sound insulator panel.
2. Stoplamp switch.
3. Cruise control switch (if equipped).
4. Wiring harness clips.





5. Brake pedal push rod retaining clip at brake pedal.





6. Brake pedal nut and bolt.
7. Brake pedal and bushings if necessary.

Clean
- All parts with suitable solvent.

Inspect
- All parts for wear. Repair or replace as needed.

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. the manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.








1. Brake pedal and bushings if removed.
2. Brake pedal nut and bolt.
- Tighten nut to 40 Nm (30 ft. lbs.).
3. Master cylinder push rod retaining clip at brake pedal.
4. Wiring harness clips.
5. Cruise control switch (if equipped).
6. Stoplamp switch.
7. Driver's side sound insulator panel.

Adjust
- Stoplamp switch.