Substandard or Contaminated Brake Fluid

CAUTION: Brake fluid may irritate eyes and skin. In case of contact, take the following actions:
^ Eye contact - rinse thoroughly with water.
^ Skin contact - wash with soap and water.

CAUTION: Use only SUPREME 11 or equivalent DOT 3 brake fluid from a clean, sealed container. Do not use fluid from an open container that may be contaminated with water. Improper or contaminated fluid will result in damage to components, or loss of braking, with possible personal injury.

NOTICE: Avoid spilling brake fluid on any of the vehicle's painted surfaces, wiring cables or electrical connectors. Brake fluid will damage paint and electrical connections. If any fluid is spilled on the vehicle, flush the area with water to minimize the potential damage.

Important:
^ Do not use power steering or transmission fluid in the brake system.
^ Do not re-use brake fluid accumulated during brake system bleeding.
^ Always store brake fluid in a closed container. Re-seal brake fluid containers immediately after use. Do not use brake fluid left in an open or improperly sealed container, because it absorbs moisture, or can become contaminated.

Improper brake fluid, mineral oil (i.e. power steering fluid and transmission fluid) or water in the fluid may cause the fluid to boil, or the rubber components in the brake hydraulic system to deteriorate. If the master cylinder cap diaphragm is swollen, then rubber parts have deteriorated. This deterioration may also be evidenced by swollen wheel cylinder boots and caliper boots.

If deterioration of rubber parts is evident, disassemble all serviceable hydraulic components and wash with alcohol. Dry these parts with non-lubricated compressed air before to keep alcohol out of the system. Replace ALL rubber parts in the system, including hoses and non-serviceable hydraulic components.

Refill the brake system with new brake fluid, flush and bleed it. Refer to BLEEDING BRAKE HYDRAULIC SYSTEM. Service and Repair