Front Fog Lamp Aiming Procedure

Description:

Horizontal aim is not adjustable on this vehicle. Vertical aim is done by an adjusting nut located on the rear of the fog lamp.

PREPARATION
^ If any service has been performed on the vehicle, make sure that all of the components are back in their original place.
^ Place the vehicle on a level surface.
^ Stop all other work on the vehicle.
^ Fill fuel tank to half full.
^ If the vehicle is intended for hauling heavy loads or tows a trailer, these loads should be simulated.

PROCEDURE
1. Move vehicle to level area and park the vehicle 7.6 m (25 feet) away from the target screen.
2. Measure from center of fog lamp to ground line, this will give you "A" Dimension from Ground Line.
3. Turn fog lamps on, the top of the fog lamp beam image on the target screen should be ("B" Dimension) 101.6 mm (4.0 inch.) below center of fog lamp lens height.
4. Adjust the fog lamp as required, using the adjusting nut on the rear of the fog lamp.