Evaporator to Accumulator Line

Refrigerant Line Connection:

Refrigerant Lines And Routing:

Refrigerant Lines To Compressor:

Remove or Disconnect

1. Air cleaner and duct assembly.
2. Recover refrigerant. Refer to "Refrigerant Recovery and Recycling, Adding Oil, Evacuating and Recharging Procedures".
3. Liquid line/suction line bracket.
4. Suction line fitting at accumulator.
5. Suction line at block fitting bolt.
6. Suction line bracket at strut tower.
7. Suction line.

Important
^ Use care when removing tube.

8. O-rings.

Install or Connect

1. New O-ring seals coated with mineral base 525 viscosity refrigerant oil.
2. Suction line into place.
3. Suction line at block fitting bolt.

Tighten
^ Bolt to 16 N.m (12 lb. ft.).

4. Suction line fitting at accumulator.

Tighten
^ Fitting to 47 N.m (35 lb. ft.).

5. Suction line bracket at strut tower.

Tighten
^ Nut to 3.3 N.m (29 lb. in.).

6. Liquid line/suction line bracket.
7. Evacuate, recharge, and leak test system. Refer to Refrigerant Recovery and Recycling, Adding Oil, Evacuating and Recharging Procedures.
8. Air cleaner and duct assembly.