Orifice to Evaporator Line

Refrigerant Line Connection:

Refrigerant Lines And Routing:

Refrigerant Lines To Compressor:

Remove or Disconnect

1. Air cleaner and duct assembly.
2. Recover refrigerant. Refer to "Refrigerant Recovery and Recycling, Adding Oil, Evacuating and Recharging Procedures".
3. Liquid line/suction line bracket.
4. ABS modulator electrical connector.
5. Liquid line fitting at orifice.
6. Liquid line at block fitting.
7. Liquid line.

Important
^ Use care when removing tube.

8. O-rings.

Install or Connect

1. New O-ring seals coated with mineral base 525 viscosity refrigerant oil.
2. Liquid line into place.
3. Liquid line at block fitting.

Tighten
^ Bolt to 16 N.m (12 lb. ft.).

4. Liquid line fitting at orifice.

Tighten
^ Fitting to 27 N.m (20 lb. ft.).

5. Liquid line/suction line bracket.
6. ABS modulator electrical connector.
7. Evacuate, charge and leak test system. Refer to "Refrigerant Recovery and Recycling, Adding Oil, Evacuating and Recharging Procedures.
8. Air cleaner and duct assembly.