Ignition & Key Alarm Switch

^ Tools Required:
- J 41352 Modular Column Holding Fixture

REMOVE OR DISCONNECT
1. Do steps 1 through 9, under "REMOVE OR DISCONNECT," refer to LOWER SHROUD, UPPER SHROUD.
2. Do steps 2 through 6, under "REMOVE OR DISCONNECT," refer to T/S & MULTIFUNCTION SWITCH ASM.
3. Key alarm switch from lock module assembly (15).
^ Gently pry retaining clip on alarm switch with small blade screwdriver.
^ Rotate alarm switch 1/4 turn and remove.





4. Two tapping screws (18).
5. Ignition & key alarm switch assembly (19).
^ Wire harness from slot in steering column tilt head assembly (26).

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems. Failure to do so may result in component damage or malfunction of steering column.

1. Ignition & key alarm switch assembly (19).
^ Route wire harness through slot in steering column tilt head assembly (26). Secure wire harness with a wire harness strap (22) through hole located in the bottom of housing assembly (26).
2. Two tapping screws (18).
^ Tighten screws (18) to 1.4 Nm (12 lb in).
3. Key alarm switch to lock module assembly (15).
a. Switch with retaining clip parallel to lock cylinder (17).
b. Rotate switch 1/4 turn until locked into place.
4. Do steps 3 through 8, under "INSTALL OR CONNECT," refer to T/S & MULTIFUNCTION SWITCH ASM.