Automatic Transmission Control Lever

REMOVE OR DISCONNECT
1. Roll back automatic transmission control lever seal from the selector lever.
2. Screw from automatic transmission control lever.
3. Automatic transmission control lever.

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

1. Automatic transmission control lever.
2. Screw to automatic transmission control lever.
^ Tighten screw to 20 Nm (14 lb ft).
3. Automatic transmission control lever seal.
^ Inspect after lever is installed be sure there is a positive shift gate feel in all positions.