Parking Brake Actuator

REMOVE OR DISCONNECT
1. Raise vehicle and suitably support.
2. Tire and wheel.
3. Brake rotor.
4. Loosen brake cables at equalizer.
5. Cable from actuator lever.
6. Parking brake return spring.
7. Cable from parking brake bracket
8. Parking brake bracket from support plate.
9. Parking brake actuator.
10. Rear wheel hub.
11. Parking brake shoe and lining.

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. the manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

1. Parking brake shoe and lining.
2. Rear wheel hub.
3. Parking brake actuator.
4. Parking brake bracket to support plate bolts.
- Tighten bolts to 10 Nm (89 inch lbs.).
5. Parking brake return spring.
6. Cable to parking brake bracket.
7. Cable to actuator lever.
8. Tighten nut on equalizer to remove cable slack.
9. Brake rotor.
10. Tire and wheel.
11. Lower vehicle.

Adjust
- Refer to PARKING BRAKE ADJUSTMENT (DISC OR DRUM). Adjustments