Turn Signal & Multifunction Switch

REMOVE OR DISCONNECT
1. Make sure lever is in center of "OFF" position.
2. Battery ground (negative) cable.
3. Disable Supplemental Inflatable Restraint (SIR).
4. Inflatable restraint steering wheel module.
5. Steering wheel.
6. Bolts/screws from lower column cover.
^ Tilt cover down and slide back to disengage locking tabs.
7. Lower column cover.
8. Bolts/screws from upper column cover.
9. Upper column cover.
10. Wire harness strap.
11. Two wire harness straps from steering column wire harness.
12. Steering column bulkhead connector from vehicle wire harness.
13. Gray and black connectors of switch from column bulkhead connector.
14. Bolts/screws from turn signal and multifunction switch.
15. Turn signal and multifunction switch.

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

1. Turn signal and multifunction switch.
^ Use small flat blade to compress electrical contact and move turn signal and multifunction switch into position.
^ Electrical contact must rest on canceling cam.
2. Bolts/screws to turn signal and multifunction switch.
^ Tighten bolts/screws to 6 Nm (53 lb in).
3. Gray and black connectors of switch to column bulkhead connector.
4. Steering column bulkhead connector to vehicle wire harness
5. Two wire harness straps to steering column wire harness.
6. Wire harness strap.
7. Upper column cover.
8. Bolts/screws to upper column cover.
^ Tighten upper column cover bolts/screws 4 Nm (38 lb in).
9. Lower column cover.
10. Bolts/screws to lower column cover.
^ Tighten lower column cover bolts/screws 4 Nm (38 lb in).
11. Make sure the lever is in the center or "OFF" position.
12. Steering wheel to column.
13. Inflatable restraint steering wheel module.
14. Enable SIR.
15. Battery ground (negative) cable.