Front Hub and Bearing

FRONT HUB/BEARING






^ Tools Required:
- J 28733-A Front Hub Spindle Remover
- Or Equivalent

REMOVAL
Remove or disconnect the following:
1. Drive axle.
2. Brake caliper bolts, and support caliper.
3. Rotor.
4. Hub and bearing assembly from steering knuckle.

INSTALLATION
Install or connect the following:
1. Hub and bearing assembly to steering knuckle.
2. Hub and bearing assembly bolts.
Tighten hub and bearing assembly bolts to 95 Nm (70 lb ft).
3. Rotor.
4. Brake caliper and bolts.
5. Drive axle.
6. Check front wheel alignment.