Rear Suspension

^ Tool Required:
- J 6627-A Wheel Stud Remover
- Or Equivalent

REMOVAL
Remove or disconnect the following:
1. Wheel and tire assembly.
2. Brake drum.

CAUTION: Do not hammer on brake drum as damage to the bearing or deformation of the drum could result.

3. Wheel stud using J 6627-A.
^ Dispose of stud.

INSTALLATION
Install or connect the following:
1. New stud (insert from back side of hub).
2. Four flat washers on stud.
3. Wheel nut (install with flat side toward washers).
4. Tighten nut until stud head is properly seated in hub flange.
5. Remove nut and washers.
6. Brake drum.
7. Wheel and tire assembly.