Fuel Injector Balance Test

Diagnostic Chart:

Description:

Locations:

Test Description

Caution: In order to reduce the risk of fire and personal Injury, wrap a shop towel around the fuel pressure connection. The towel will absorb any fuel leakage that occurs during the connection of the fuel pressure gauge. Place the towel In an approved container when the connection of the fuel pressure gauge is complete.

4. The engine coolant temperature must be below the operating temperature in order to avoid irregular fuel pressure readings due to Hot Soak fuel boiling.

5. The fuel pressure should be within the specified range. If the fuel pressure is not within the specified range. go to powertrain Diagnostic System Check. Testing and Inspection

6. The fuel pressure should reach a steady value. If the fuel pressure does not reach a steady value, go to Powertrain OBD System Check.

7. If the pressure drop value for each fuel injector is within 10 kPa (1.5 psi) of the average pressure drop value, the fuel injectors are flowing properly. Calculate the pressure drop value for each fuel injector by subtracting the second pressure reading from the first pressure reading. Refer to the illustration above.