Balance Shaft
TIGHTENING SPECIFICATIONSHousing Bolts 10 mm hex 15 Nm (11 lb ft)+40°
Cover Nut and Bolt 13 Nm (115 lb in)
Housing to Thrust Plate 13 Nm (115 lb in)
Shaft To
Housing Bolts 8 mm hex 10 Nm (89 lb in)+45°
Block Bolts 13 mm hex 25 Nm (18 lb ft)
Block Bolts 15 mm hex 53 Nm (39 lb ft)
Block Bolts 18 mm hex 40 Nm (30 ft. lbs)+60°
Crankshaft 175 Nm (129 lb ft)+90°
DIMENSIONS
Bore Roundness 0.025 mm (0.0009 inch)
Endplay 0.185-0.455 mm (0.0073-0.0179 inch)
Bearing
Thickness 1.500-1.508 mm (0.0590-0.0593 inch)
I.D. 30.019-30.061 mm (1.1819-1.1835 inch)
Journal
Taper 0.000-0.010 mm (0.000-0.0004 inch)
Roundness (max.) 0.005 mm (0.0002 inch)
Housing
Bore 33.025-33.050 mm (1.3001-1.1801 inch)
Flatness Maximum 0.076 mm (0.0030 inch)
Shaft
Journal O.D. 29.950-29.975 mm (1.1791-1.1801 inch)
Groove Width 3.23-3.40 mm (0.127-0.134 inch)