- Disabling/Enabling the SIR System

Remove or Disconnect

^ Turn the steering wheel so that the vehicle's wheels are pointing straight ahead.
^ Turn ignition switch to "LOCK" and remove key.
1. "AIR BAG" fuse from I/P fuse block.
2. Connector Position Assurance (CPA) and yellow 2-way SIR harness connector at the base of the steering column, through "trap" door in LH sound insulator.

Important
^ With the "AIR BAG" fuse removed and ignition switch "ON", the "AIR BAG" warning lamp will be "ON". This is normal operation and does not indicate an SIR system malfunction.

Install or Connect

^ Turn the ignition switch to "LOCK" and remove key.
1. Yellow 2-way SIR harness connector and (CPA) at the base of the steering column, through "trap" door in LH sound insulator.
2. "AIR BAG" fuse to I/P fuse block.
^ Turn ignition switch to "RUN" and verify that the "AIR BAG" warning lamp flashes 7 times and then turns "OFF". If it does not operate as described, perform the "SIR Diagnostic System Check". Testing and Inspection