SIR Coil Assembly

SIR Coil Assembly:

Centering Coil Assembly:

Remove or Disconnect

^ Disable the (SIR) system.
1. Negative battery cable.
2. Steering wheel assembly.
3. Column covers.
4. Coil assembly retaining clip.
5. Coil assembly off shaft end letting coil hang freely.
6. Filler panel.
7. Disconnect coil wire from harness.

Install or Connect

1. Route coil wire through retaining clips on column.
2. Ensure coil assembly is centered.

Important
^ Assemble pre-centered coil assembly to steering column. Remove centering tab and dispose.

Important
^ Coil assembly will become un-centered if:
a. Steering column is separated form steering gear and is allowed to rotate.
b. Centering spring is pushed down, letting hub rotate while coil is removed from steering column. In the event this occurs, refer to "Centering Coil Assembly".

3. Coil assembly retaining ring.
^ Ring must be firmly seated in groove on shaft.

Important
^ Gently pull lower coil assembly wire to remove any wire kinks that may be Inside column assembly. It is absolutely critical that you make sure there are no kinks or bends In the SIR coil assembly wire. If a kink or bend is present, interference may occur with the shaft lock mechanism. Then turning of the steering wheel may cut or damage wire.

4. Column covers.
5. Steering wheel assembly.
6. Connect coil wire to harness.
7. Negative battery cable.
^ Enable the SIR system.