Radio Replacement

REMOVAL PROCEDURE
1. Remove the IP cluster trim panel.
2. Remove the fasteners that secure the radio.
3. Pull rearward the radio.
4. Disconnect the electrical connector(s).
5. Disconnect the antenna lead.
6. If you replace the radio, remove the mounting bracket from the radio.

INSTALLATION PROCEDURE
1. If the radio was replaced, install the old mounting bracket.
2. Connect the antenna lead.
3. Connect the electrical connector(s).
4. Install the radio.

NOTICE: Refer to Fastener Notice in Cautions and Notices.

5. Install the radio fasteners.

Tighten
Tighten the fasteners to 1.9 N.m (17 lb in).

6. Install the IP cluster trim panel.