Glove Compartment: Service and Repair

REMOVAL PROCEDURE




1. Open the Instrument Panel (IP) compartment.
2. Pull down the IP compartment stops. Allow the compartment to travel past the stops.
3. Remove the rear compartment release enable switch/oil reset switch, if equipped.
4. Disengage the retainer fastening the electrical connector to the rear of the IP compartment.
5. Remove the IP compartment light (1) from the IP compartment assembly.




6. Close the IP compartment.
7. Remove the fasteners (1) securing the IP compartment to the IP.
Remove the IP storage compartment hinge trim (2).
8. Open the IP compartment in order to remove the IP compartment.

INSTALLATION PROCEDURE




1. Install the IP compartment to the IP.
Place the IP compartment in the closed position.
2. Install the hinge trim (2) to the hinge.

NOTICE: Refer to Fastener Notice in Cautions and Notices.

3. Install the fasteners (1) in order to secure the IP compartment to the IP.

Tighten
Tighten the fasteners to 1.9 N.m (17 lb in).




4. Open the IP compartment.
5. Pull down the IP compartment stops. Allow the compartment to travel past the stops.
6. Install the IP compartment light (1) to the IP compartment.
7. Connect the electrical connector retainer to the rear of the IP compartment.
8. Install the rear compartment release enable switch/oil reset switch, it equipped.
9. Close the IP compartment.