Side Rear Door Trim Panel

REMOVAL PROCEDURE

TOOLS REQUIRED
J 38778 Door Trim Pad and Clip Remover

1. Remove the switch plate.
2. Remove the retaining fasteners (1) from the switch plate opening.
3. Release the retaining tab on the courtesy lamp. Use a small, thin-bladed tool.
4. Remove the courtesy lamp.
5. Disconnect the electrical connector.
6. Remove the retaining fastener (4) through the courtesy lamp opening.
7. Remove the door lock switch bezel.
8. Release the trim panel retainers.
Insert the J 38778 between the outer edges of the trim panel and the door.
9. Remove the trim panel.
10. Remove the wiring harness from the trim panel.

INSTALLATION PROCEDURE
1. Install the wiring harness to the trim panel.
2. Align the trim panel to the door.
3. Install the trim panel to the door.
Push on the outer edges of the trim panel.
4. Install the door lock switch bezel.

NOTICE: Refer to Fastener Notice in Cautions and Notices.

5. Install the retaining fastener (4) through the courtesy lamp opening.

Tighten
Tighten the fastener to 1.8 Nm (16 lb in).

6. Connect the courtesy lamp electrical connector.
7. Install the courtesy lamp to the trim panel.
8. Install the retaining fasteners (1) through the switch plate opening.

Tighten
Tighten the fastener to 1.8 Nm (16 lb in).

9. Install the switch plate.