Backup Lamp: Service and Repair

REMOVAL PROCEDURE
1. Remove the caps covering the backup lamp retaining studs.
2. Remove the screws at the outer ends of the backup lamp assembly (2).
3. Remove the screws from the license plate pocket.
4. Remove the screws that retain the license plate lamps.
5. Remove the nuts (1) that retain the backup lamp assembly (2).

INSTALLATION PROCEDURE

NOTICE: Refer to Fastener Notice in Cautions and Notices.

1. Install the nuts (1) in order to retain the backup lamp assembly.

Tighten
Tighten the nuts (1) to 5 N.m (44 lb in).

2. Install the screws in order to retain the license plate lamps.
3. Install the screws in the license plate pocket.

Tighten
Tighten the screws to 3.5 N.m (31 lb in).

4. Install the screws to the outer ends of the backup lamp assembly (2).

Tighten
Tighten the screws to 5 N.m (44 lb in).

IMPORTANT: Do not rework or alter the reflective surface of the taillamps.

5. Install the caps to the backup lamp retaining studs.