SSEI

REMOVAL PROCEDURE
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the electrical connector.
3. Remove the nuts (3) that retain the fog lamp (2) to the impact bar (1).
4. Remove the fog lamp (2).

INSTALLATION PROCEDURE

IMPORTANT: Inspect the fog lamp aim after the installation of the fog lamp. Refer to Fog Lamp Aiming Procedure.

1. Install the fog lamp (2).

NOTICE: Refer to Fastener Notice in Cautions and Notices.

2. Install the nuts (3) in order to retain the fog lamp (2) to the impact bar (1).

Tighten
Tighten the nuts (3) to 3.2 N.m (28 lb in).

3. Install the electrical connector to the fog lamp (2).
4. Lower the vehicle.