Headlamps Replacement

REMOVAL PROCEDURE
1. Remove the 2 bolts (3) at the inboard edge of the headlamp (2).
2. Position the headlamp outboard in order to disengage the pins (1) at the rear of the headlamp (2).
3. Remove the electrical connectors from the headlamp (2).
4. Remove the bulbs from the headlamp (2).

INSTALLATION PROCEDURE
1. Install the bulb to the headlamp (2).
2. Install the electrical connectors.
3. Position the headlamp inboard in order to engage the pins at the rear of the headlamp (2).

NOTICE: Refer to Fastener Notice in Cautions and Notices.

4. Install the 2 bolts (3) to the inboard edge of the headlamp (2).

Tighten
Tighten the bolts (3) to 5 N.m (44 lb in).

5. If you are installing a new headlamp (2), remove the horizontal aim adjuster restrictor from the headlamp (2). Discard the horizontal aim adjuster restrictor.
6. Inspect the headlamp aim. Refer to Headlamp Aiming. Aiming the Headlamps