Accelerator Cable Bracket

REMOVAL PROCEDURE




1. Remove the fuel injector sight shield. Refer to Engine Cover Replacement Service and Repair.




2. Rotate the throttle lever.
3. Remove the cruise control cable (1) from the accelerator controls cable bracket (2).




4. Disconnect the accelerator control cable (2) from the accelerator controls cable bracket (1).




5. Remove the wiring harness clip (1) from accelerator controls cable bracket (3).




6. Remove the two bolts from the accelerator controls cable bracket.



INSTALLATION PROCEDURE

NOTICE: Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless the can be securely fastened. This is necessary in order to prevent possible interference and damage to the component.

1. Install the two bolts to the accelerator controls cable bracket.
^ Tighten the bolts to 16 Nm (12 ft. lbs.).

NOTICE: Refer to Service Precautions / Fasteners.

2. Install wiring harness clip (1) to the accelerator controls cable bracket (3).
3. Install the accelerator controls cable (2) to the accelerator controls cable bracket (1).
4. Install the cruise control cable (1) to the accelerator controls cable bracket (2).

IMPORTANT: The throttle should operate freely, without binding, between full closed and wide open throttle.

5. Check for complete throttle opening and closing positions by operating the accelerator pedal. Also check for poor carpet fit under the accelerator pedal.
6. Install the fuel injection sight shield. Refer to Engine Cover Replacement Service and Repair.

NOTICE: Refer to Service Precautions / Fasteners.