Cabin Temperature Sensor / Switch: Service and Repair

Inside Air Temperature Sensor:

Remove or Disconnect

1. IP lower trim plates (snap out).
2. Air deflectors (snap out).
3. IP accessory trim plate retaining screws and plate.
4. Aspirator hose and sensor assembly.
5. Inside temperature sensor.
6. Electrical connector.

Install or Connect

1. Electrical connector.
2. Inside temperature sensor to aspirator hose.
3. Aspirator hose and sensor to IP.
^ Make sure hose routing is not crimped or bent when installing.
4. IP accessory trim plate and retaining screws.
5. Air deflectors (snap in).
6. IP lower trim plates (snap in).