Rear Camber Adjustment

ADJUSTMENT PROCEDURE
^ Tools Required:
- J 29862 Camber Adjustment Tool

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

1. Loosen the strut to knuckle mounting nuts.

Tighten
Tighten the strut to knuckle mounting bolts, using J 29862, to 190 Nm (140 ft. lbs.). Refer to WHEEL ALIGNMENT SPECIFICATIONS.

2. Remove J 29862.