Power Window Motor

Removal Procedure




1. Ensure that the window is 3 cm (1 in) below the full up position.
2. Disconnect the negative battery cable.
3. Remove the trim panel.
4. Remove the water deflector.





Caution: If this procedure must be done with the regulator out of the vehicle, the counterbalance spring must be removed first. The regulator lift arms are under tension from the counterbalance spring and can cause serious injury if the motor is removed without removing the spring.

5. Disconnect the electrical connector (3).
6. Remove the fasteners.
7. Remove the actuator (2).

Installation Procedure

1. Install the actuator (2).
Install the fasteners.
2. Connect the electrical connector.
3. Install the water deflector.
4. Install the trim panel.
5. Connect the negative battery cable.