Wiper Motor Cover Replacement

REMOVAL PROCEDURE




1. Disconnect the electrical connectors from the cover and the wiper motor.




2. Remove three screws.
3. Remove the wiper motor cover.

INSTALLATION PROCEDURE

NOTICE: Refer to Fastener Notice in Cautions and Notices.

IMPORTANT: Always install the cover with the wiper motor in the park position and the drive pin in the open area of the cam.




1. Install the wiper motor cover.
2. Install three screws.

Tighten

Tighten the screws to 3 N.m (26 lb in).




3. Connect the electrical connectors onto the cover and the wiper motor.