Exhaust Manifold Installation (Right Side)

1.Install the right exhaust manifold and gasket.
2. Install the right exhaust manifold studs.
Tighten the right exhaust manifold studs to 30 Nm (22 ft. lbs.).

Notice: Refer to Fastener Notice in Service Precautions.





3. Install the fuel injector sight shield cover bracket.
4. Install the fuel injector sight shield cover bracket nuts.
Tighten the fuel injector sight shield bracket nuts to 30 Nm (22 ft. lbs.).





5. Install the heated oxygen sensor lead.





Important: Inspect the EGR inlet pipe for leaks during installation. If leaks are present, replace the EGR adapter assembly.

6. Install the EGR mounting bracket.
7. Install the EGR mounting bracket bolts.
Tighten the EGR mounting bracket bolts to 50 Nm (37 ft. lbs.).
8. Install the EGR inlet pipe to the exhaust manifold.
9. Install the EGR inlet pipe bolt.
Tighten the EGR inlet pipe bolt to 29 Nm (21 ft. lbs.).