Instrument Panel Harness Connector Bracket Replacement

IP To Body Connections - Left Side:

REMOVE OR DISCONNECT
1. Left sound insulator.
2. Push on lever on bracket at rear edge to lower bracket to gain access to connectors.
3. Unplug all connectors and antenna lead from bottom of bracket.
4. Four fasteners from bracket, three are at the bottom, the left upper fastener is located above bracket approximately 125 mm(5 inches).
5. Connectors from bracket.

INSTALL OR CONNECT
1. Connectors to bracket.
2. Bracket to IP carrier.
3. Connect harness that was removed into connectors on bracket.
4. Push up on lever to unlock bracket.
5. Push bracket up until bracket latches.