Tilt Wheel Spring

Tilt Steering Column (Part 1 Of 2):

REMOVAL PROCEDURE
1. Do steps 1 through 3 under REMOVAL PROCEDURE in ELECTRICAL (BTSI) ACTUATOR C/S.
2. Do steps 3 through 7 under REMOVAL PROCEDURE in UPPER SHROUD, LOWER SHROUD.





3. Use the tilt lever to tilt the column to the "UP" position.





Caution: The tilt spring (20) and spring guide (21) are under pressure and could become a projectile. During removal and installation secure the spring with locking pliers. Exercise caution when removing or installing spring and guide, as bodily injury may result.

4. Remove the tilt spring (20).
A. Pry the spring up until a bulge occurs and most of the spring tension is removed.
B. Secure the spring with the locking pliers and continue prying until the spring disengages from the post on the steering column support assembly and steering column tilt head assembly.





5. Remove the spring guide (21) from the tilt spring.

INSTALLATION PROCEDURE

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems. Failure to do so may result in component damage or malfunction of steering column.





1. Install the spring guide (21) to the tilt spring (20).





2. Install the tilt spring with the guide.
A. Spring to the post on the steering column support assembly (57).
B. Secure the spring with locking pliers.
C. With the end of the spring on the post, pull on the center of the spring while pushing the guide end to the post on the steering column tilt head assembly (26).
D. With both ends installed to the post, push the spring into position.
3. Raise or install the steering column to the vehicle.
4. Do steps 1 through 9 under INSTALLATION PROCEDURE in UPPER SHROUD, LOWER SHROUD.