Crankshaft Balancer Installation

Tools Required
^ J 37096 Flywheel Holding Tool
^ J 36660 Torque Angle Meter

1. Lubricate the seal surface of the crankshaft balancer with engine oil.
2. Install the crankshaft balancer.
3. Use J 37096 to hold the flywheel.

Notice: This bolt is designed to permanently stretch when tightened. The correct part number fastener must be used to replace this type of fastener. Do not use a bolt that is stronger in this application. If the correct bolt is not used, the parts will not be tightened correctly. The system or the components may be damaged.

4. Install the crankshaft balancer bolt.
Tighten the crankshaft balancer bolt to 150 Nm (111 ft. lbs.). Use J 36660 to tighten the crankshaft balancer bolt an additional 76 degrees.

Notice: Refer to Fastener Notice in Service Precautions.