Crankshaft Balancer Installation (Automatic Transmission)

^ Tools Required
- J 37096 Flywheel Holding Tool
- J 36660 Torque Angle Meter





1. Lubricate the seal surface of the crankshaft balancer with engine oil.
2. Install the crankshaft balancer.
3. Use J 37096 to hold the flywheel.
4. Install the crankshaft balancer bolt.
^ Tighten the crankshaft balancer bolt to 150 Nm (111 ft. lbs.). Use J 36660 to tighten the crankshaft balancer bolt an additional 76 degrees.

Notice:
^ This bolt is designed to permanently stretch when tightened. The correct part number fastener must be used to replace this type of fastener. Do not use a bolt that is stronger in this application. If the correct bolt is not used, the parts will not be tightened correctly. The system or the components may be damaged.
^ Refer to Fastener Notice in Service Precautions.