Accelerator Controls Cable Bracket Replacement

Description:

Removal Procedure
1. Remove the fuel injector sight shield. Refer to Engine Cover Replacement Service and Repair.
2. Rotate the throttle lever.

Description:

3. Disconnect the cruise control cable (1) from the bracket (2).

Description:

4. Disconnect the accelerator cable (2) from the bracket (1).

Description:

5. Remove the wiring harness clip (1) from bracket (3).




6. Remove the two bolts from the bracket.


Installation Procedure

NOTICE: Do not route flexible components (hoses, wires, conduits, etc.) within 50 mm (2 in) of moving parts unless the can be securely fastened. This is necessary in order to prevent possible interference and damage to the component.

1. Install the two brackets bolts.

Tighten
Tighten the bolts to 16 Nm (142 lb. in.).

NOTICE: Refer to Fastener Notice in Service Precautions.

2. Install wiring harness clip (1 ) to the bracket (3).
3. Install the accelerator cable (2) to the bracket (1).
4. Install the cruise control cable (1) 10 the bracket (2).

IMPORTANT: The throttle should operate freely, without binding, between full closed and wide open throttle.

5. Check for complete throttle opening and closing positions by operating the accelerator pedal. Also check for poor carpet fit under the accelerator pedal.
6. Install the fuel injection sight shield. Refer to Engine Cover Replacement Service and Repair.