Rear Door - Sedan

POWER WINDOW SWITCH
Rear Door - Sedan

REMOVAL PROCEDURE





IMPORTANT: When removing a door trim panel or switch plate, the ignition switch must be in the OFF position. This will eliminate the possibility of shorting out the switch if a flat-bladed tool, awl or metal object is used to remove the switch from the harness.

IMPORTANT: Use a protective coating/tape at the point of insertion of the flat surface tool. Damage to the inner door panel may occur if it is not protected.

1. When removing a power window switch (front or rear door), insert a plastic, flat bladed tool at the front edge of the switch mounting plate. Press rearward to release the mounting plate retainer and lift up on the front of the plate.
2. Remove the switch from the bezel.
3. Remove the switch from the bezel.




4. Disconnect the electrical connector from the power window switch.
5. Remove the switch from the door.

INSTALLATION PROCEDURE




1. Install the switch tabs into the bezel slots.
2. Press down on the tabs in order to secure the switch.
3. Connect the electrical connector to the window switch.




4. Align the bezel to the door trim panel opening and press into place to secure.