SIR Coil Assembly

Tilt Steering Column - Part 1 Of 2:

Tilt Steering Column - Legend - Part 2 Of 2:

Removing SIR Coil Assembly:

^ Tools Required:
- J 41352 Modular Column Holding Fixture

REMOVE OR DISCONNECT
1. Do steps 1 through 9 under REMOVE OR DISCONNECT, in LOWER SHROUD, UPPER SHROUD.
2. Air bag module and steering wheel.

NOTICE: SIR coil assembly (2) will become uncentered if:
1) Steering column is separated from steering gear and allowed to rotate.

Centering SIR Coil Assembly:

2) Centering spring is pushed down, letting hub rotate while coil (2) is removed from steering column. (If this occurs center the coil.)

3. Retaining ring (30).
4. SIR coil assembly (2).
5. Wave washer (3).
6. Two wire harness straps (22) from steering column wire harness.

INSTALL OR CONNECT

NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application. The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems. Failure to do so may result in component damage or malfunction of steering column.

1. Center race & upper shaft assembly (34) and SIR coil assembly (2).
A. Wheels straight ahead.
^ Block tooth and centering mark on shaft assembly (34) at 12 o'clock position.
B. Ignition switch to "LOCK" position.
C. Ensure coil (2) is centered.
2. Wave washer (3).

NOTICE: New SIR coil assembly (2) will be pre-centered. Install new coil, remove and dispose of centering tab.

3. SIR coil assembly (2).
A. Ensure shaft (34) and coil (2) are centered.
B. Align coil (2) with horn tower and slide onto shaft (34).
4. Retainer ring (30).
^ Retainer ring (30) must seat securely in groove on shaft (34).
5. Route lower coil wire along steering column jacket assembly (58).
6. Two wire harness straps (22) to steering column wire harness.
7. Do steps 4 through 13 under INSTALL OR CONNECT, in LOWER SHROUD, UPPER SHROUD.
8. Steering wheel and air bag module.
9. If all service operations are completed, enable the SIR system; refer to ENABLING THE SIR SYSTEM.
10. Negative (-) battery cable.